|
|
Read all
safety instructions and Operations
Manual before using heat tool. |
|
|
When
working with any type of heat or
open flame, always keep a fire
extinguisher close by. |
|
|
Always
were safety glasses and gloves
(flame retardant or leather is
suggested) when shrinkwrapping. |
|
|
Never
obstruct or cover the air inlet. If
the air flow is reduced the heat
tool will not work properly. |
|
|
When
shrinkwrapping outdoors, do not
shrinkwrap when the wind is harder
the 10 mph. |
|
|
When
shrinkwrapping indoors, make sure
the work area is well ventilated. |
|
|
Keep
work area clear of debris, wood
shavings, paper products, flammable
chemicals and anything else that may
catch fire from the heat of the
tool. |
|
|
Do not
wear loose clothing while
shrinkwrapping and also keep long
hair tied back. |
|
|
Stay
alert, watch what you are doing, and
use common sense when operating the
heat tool. Do not use tool while
tired or under the influence of
drugs, alcohol or medication. A
moment of inattention while
operating the heat tool may result
in serious personal injury. |
|
|
Do not
overreach. Keep proper footing and
balance at all times. Proper footing
and balance enables better control
of the heat tool in unexpected
situations. |
|
|
Never
operate the heat tool with the
combustor nozzle hard up against a
surface; this could ignite any
material you are shrinkwrapping. |
|
|
Never
keep the heat on one area for more
then a few seconds. Once heat is
applied to the shrink film, it will
continue to shrink even after the
heat is moved away from the area. |
|
|
Do not
place the nozzle next to anything
while it is hot. |
|
|
Never
touch the combustor nozzle with
clothing or skin. |
|
|
Do not
look down the combustor while the
tool is turned on or attached to a
fuel source. |
|
|
Do not
insert anything down the combustor
of the tool. |
|
|
Hidden
areas such as behind walls,
ceilings, floors, soffit boards and
other panels may contain flammable
materials that could be ignited by
the heat tool when working in these
locations. The ignition of these
materials may not be readily
apparent and could result in
property damage and injury to
persons. When working in these
locations, keep the heat tool moving
in a back-and-forth motion.
Lingering or pausing in one spot
could ignite the panel or the
material behind it. |
|
|
Never
modify the tool in any way and use
only Shrinkfast replacement parts |
|
|
Never
use the tool on an area that you can
not see. |
